[ BACK ]
Two part installation with a rear mounting heatsink and a control panel for front mount location, visible for remote control of volume level & cut-off frequency. High power & High current design for excessive bass. Enough horsepower to move any sized driver up to 18"! Low noise circuit. Line level in & outs for home theatre. Also speaker wire in & outs for Satellite speaker applications. Easy installation & setup. Attractive flush design. 240Vac. Phase toggle switch. Adjustable low-pass filtering (60Hz 180Hz). Stable into 4 ohms at full power down to the subsonic (-3dB 20Hz). Upper cut-off frequency is adjustable from 40Hz to 160Hz. Bass boost +6dB at 35Hz. Auto power activation. SSS Improved CCT. Amp Hole cut-out is 235x285mm, Open inside for heat dissipation. Module Cut-out is 125x65mm. Remote control (AAA inc.). Power 400Wrms+ (1000Wmax) S400W | |
"This unit has been upgraded by the services of
Stones Sound Studio
to achieve an impressive 400WRMS! Our bench tests into a static non-inductive 4 ohm dummy load showed a frequency response stable to below 10Hz and an output that far exceeded the claimed 400Wrms, infact over 500W! All day!" WES Team 2005 This is our top-of-the-line subwoofer amplifier module. As well as a phase
reversal switch, Hi & Lo inputs, Hi & Lo outputs and an 'auto-on' function, this
module features infrared remote control of both volume and crossover frequency.
Now you can easily adjust the amp's output from anywhere in the room, making it
ideal for adjusting the optimum settings from your favourite listening chair.
|
This unit has been upgraded by the services of
Stones Sound
Studio to achieve an impressive 400WRMS!
Our bench tests into a static non-inductive 4 ohm dummy load showed a frequency
response stable to below 10Hz and an output that far exceeded the claimed
400Wrms, infact over 500W! All day!
Response Graphs:S200W - S200ETH |
Circuit Diagrams
|